Ergebnis der Verschleißvermessung

Concepts for reducing friction and wear

Your goals:

  • Optimization of components with regard to wear resistance
  • Selection and evaluation of optimal materials and coatings
  • Optimization of friction through the use of suitable materials
  • Optimization of friction through functional surface topographies
  • Prevention of tribological damage

Our portfolio:

  • Advice on the use of optimal materials, coatings and surface topography
  • Performing tribological damage analyzes
  • Tribometer tests for the simulation of all wear mechanisms (adhesion, furrow, surface crushing and tribocorrosion)
  • Combined load (temperature, corrosion)
  • Tribometer tests for the assessment of friction and wear behavior (harmanalytic, gravimetric)
  • Damage analysis: SEM, LIMI, tactile or optical surface measurement and evaluation
  • Near-close tests – e.g. Different bearing test stands

Gallery

Recommendation

CFD- and FEM-Simulation

Your Goals: Improvement of plant efficiency and component optimization by simulation of technical flows in furnace components (burners, fans etc…) […]

1 MW pilot plant

Your goals: Examination of burners, components and devices under operating conditions in trial operation with process and metallurgical gases from […]

New measuring instrument for the determination of the combustion technology properties of process, mixed and natural gases

Your goals: Efficient combustion of process, mixed and natural gases even in the case of changes in the fuel gas […]

Recycling of process residues by injection into metallurgical processes

Initial situation: Fine-grained process residues (eg filter dust or dried sludge) often contain considerable amounts of metals, alloying components and […]