1 MW pilot plant

Your goals:

Examination of burners, components and devices

  • under operating conditions
  • in trial operation with process and metallurgical gases from the factory network
  • with defined preheated combustion air and / or fuel gas
  • with controlled furnace room temperature by heat sink
  • with a defined atmosphere in near stoichiometry strongly over- or under-stoichiometric operation
  • with high-resolution measurement of the reaction sequence in the area of the flame

Our portfolio:

  • Flexible burner tests on own test facility
  • Connections up to 1 MW
  • Electrical connection: up to 3 x 50 kW (400 V, 125 A)
  • Combustion gases: natural gas, blast furnace gas, coke gas
  • Technical gases: Oxygen, nitrogen, H2 up to 60 % by means of coke oven gas, 100 % H2 possible via cylinders
  • Combustion air preheating up to 1,100 ° C
  • Fuel gas preheating up to 500 ° C
  • Burnout measurements in flame
  • Local analysis measurements via flexible probes (O2, CO, CO2, NOX, T, … ..)
  • Flexible, digital measurement acquisition
  • Photo and video documentation (e.g. UV camera)

 

 

Recommendation

Knowledge management through semantic modeling

Communication between autonomous systems requires a common language and uniform semantics. Furthermore, due to the increasing complexity of the entire […]

Optimization of dedusting

Goals: Cost-effective inventory and assessment of existing plants with regard to dust emissions and the efficiency of dedusting Proposal and […]

FIDUS – Touchless check for internal and surface defects

Testing bars and wire under 15 mm diameter at high speed for internal defects was been difficult so far. Wire […]

Optimization of block casting

Your goals: Cost-effective evaluation of possible process changes Improve product quality Avoiding rejects Our portfolio: Design / optimization of pouring […]